Maintenance Plans

Cooling System Checkup

• Condenser fan blade inspection and test
• Condenser motor inspection and test
• Test capacitor for fan mode
• Test capacitor for compressor mode
• Inspect contactor
• Inspect condenser coil
• Inspect and test compressor
• Test shredder valves
• Test disconnect switch
• Test refrigerant level
• Inspect refrigeration line insulation
• Inspect coil drain
• Inspect supply and return plenums
• Check filter
• Inspect low voltage wiring
• Check all low voltage connections
• Test low-pressure switch
• Test high-pressure switch
• Check AC level
• Check for airflow around AC
• Test thermostat
• Check Low side temperature
• Check High side temperature
• Check subcooling
• Check superheat

Furnace Check-Up

• Blower Motor Inspection and test
• Blower Wheel Inspection and test
• Circuit board inspection and test
• Inducer Motor inspection and test
• Heat Exchanger Inspection
• Burners Cleaned and Inspected
• Flame Sensor Inspected and tested
• Carbon Monoxide leaks checked
• Ignitor Inspection and test
• Thermocouple Inspection and test
• Capacitor tested
• Low voltage wire inspected
• Connections checked
• Gas valve inspection and test
• Plenum and Duct inspection
• Flue pipe inspection
• Shutoffs tested and inspected
• Humidifier turned on and off
• Check filter
• Check thermostat
• Perform Temperature rise test
• Check drain and trap
• Check water sensor
• Inspect flue termination

Boiler Maintenance Plan:

• Inspect flue for cracks and gaps
• Ensure flue is not compromised
• Check Intakes and Air supply
• Test gas pressure
• Adjust gas pressure
• Adjust flame
• Test safety relief
• Inspect and Test shot off valves
• Check all electrical connections
• Check all gas connections
• Check proper amp draws
• Check pumps
• Grease pumps as needed
• Check heat exchanger for obstruction and cracks
• Check proper ventilation draft
• Check carbon monoxide levels
• Examine drain from system
• Check and clean burners
• Turn system on
• Inspect flame
• Test thermostat

Water Heater Maintenance Plan
Water heater inspection and cleaning can ensure proper safe operation, but also help to avoid any potential damage from a leaking tank.

• Inspect flue for cracks and gaps
• Ensure flue is not compromised
• Check Intakes and Air supply
• Test gas pressure
• Adjust gas pressure
• Adjust flame
• Test safety relief
• Inspect and Test shot off valves
• Check all electrical connections
• Check all gas connections
• Check proper amp draws
• Check pumps
• Grease pumps as needed
• Check heat exchanger for obstruction and cracks
• Check proper ventilation draft
• Check carbon monoxide levels
• Examine drain from system
• Check and clean burners
• Turn system on
• Inspect flame
• Test Thermostat